Skip to main content

VPS: Installation of Docker

This guide was created with the following products:

(Details may vary with products from different providers but the main concepts remain the same)

Introduction

Docker is a lightweight, open source virtualization software to provide services or applications in isolation on a single system. In contrast to real virtual machines, no extra operating system is emulated or hosted for this, but rather only an application environment within the host system. This not only saves resources in general, but at the same time causes a low overhead compared to full virtualization.

How do I install Docker on my Linux server?

info

In this example we set up Docker on a Debian 9 system and install it via package sources. There may be deviations in another operating system!

Step 1: Connect to your server with Putty.

Step 2: As far as you are connected to your server via Putty, the GPG key, i.e. the key file from Docker, must be added to our system at the beginning:

apt-key adv –keyserver hkp://p80.pool.sks-keyservers.net:80 –recv-keys 58118E89F3A912897C070ADBF76221572C52609D

Then we add Docker to our package sources so that we can install the package via apt-get.

echo "deb https://apt.dockerproject.org/repo debian-jessie main" >> /etc/apt/sources.list.d/docker.list 

Step 3: Now we can download Docker. It is important that we still enable apt-get to download packages from HTTP (S) pages. Here is the command:

apt-get -y install apt-transport-https ca-certificates 

Press enter and let it run. Then enter and execute the following commands:

apt-get update && apt-get -y install docker-engine
systemctl start docker
systemctl enable docker

Check if the Docker installation was successful

When all of that is done, we can see if Docker is running:

systemctl status docker 

If it looks like this and it says "Active (running)" then Docker was installed completely without any problems. With a docker run hello-world you can then check whether Docker is also running correctly. The output should look like this:

Conclusion

Congratulations, you have successfully installed and configurated Docker! If you have any further questions or problems, please contact our support team, who are available to help you every day!